![]() My basilisk is seen as a Mac IIci with a 68040 and a ?performa.rom (not sure of this one) with a Mac OS 7.5.5 running on itįor me, the trickiest part was to format a disk which was bigger than 20MB on a Mac SE running System 6. (I created a 4GB disks for my main Mac II cx image but it was painful to get it to work)Ĭhdman - MAME Compressed Hunks of Data (CHD) manager 0.139.1 (Sep 6 2010) ![]() The disks were created using chdman -createblankhd with nonsensical values, calculated using I use -createhd and -extract to go back and forth between mess and basilisk Now, what's the CHD command for converting the Basilisk II hard disk image for use with MESS? Obviously the big plus here is that the Mac version of Basilisk II automatically shares the host filesystem so you don't have to jump through hoops in order to convert and/or extract disk images. Go to the appropriate control panel and make sure AppleTalk is disabled. Remove the Disk Tools image from the list of boot devices and boot the emulated Mac from the HDD image. Shut down the emulated Mac, and start Basilisk II again. Select your new HDD as installation target and select 'Custom installation for any Mac' (or words to that effect). Use Disk Copy to mount all of them, then run the installer from disk image #1. Still inside the emulated Mac, browse to the folder where you downloaded the System 7 images and copy them all to a folder on your HDD image. Open it and browse to where you extracted Disk Copy 6.3.3.smi, copy it to your HDD image and run it. This has full R/W access to the host filesystem, so be careful - if you throw something in the trash on the emulated Mac, you can't get it back! You should see a volume named "unix" on the desktop of the emulated Mac. In the Basilisk GUI, 'create' and mount a 20MB hard disk.īoot from the Disk Tools Image (woo!) if it works, a prompt should appear asking you to initialize the HDD image. Disk Copy 6.3.3 should be in compressed smi.bin format, doubleclick on it to extract it. Set the Disk Tools disk image as boot device.ĭownload Disk Copy 6.3.3 and the System 7 installation disk images from Apple or elsewhere. Set the model to Quadra 900 and point the emulator to your quadra.rom. In the Basilisk II GUI, set refresh rate to dynamic, set a resolution you like. On OS X (sorry Windows peeps) you can do this:ĭownload Basilisk II for Mac OS from here:įind a Quadra.rom/Quadra650.rom and a bootable System 7 or 8 disk image, usually it's called "Disk Tools". As of 5 minutes ago I have a 20MB System 7.5 "for any mac" installation up and running in Basilisk II.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |